BaerCoil Wire Thread Inserts UNC 1/4 x 20 - 2.0 D (12.7 mm) - free running - 10 pcs.
In stock
Express shipping available
BaerCoil Wire Thread Inserts UNC 1/4 x 20 - 2.0 D (12.7 mm) - free running - 10 pcs.
BaerCoil® thread inserts are the best solution for your thread repair! With them you can create long-lasting and powerful threaded connections. The inserts also ensure that you have no waste and recycle everything. The inserts are precise and wear resistant - your screw will stay firmly in place without the thread insert slipping.
The BaerCoil® thread insert is the perfect solution for damaged threads while maintaining the same nominal diameter. For thread repair with wire thread inserts, the thread is drilled out and a new STI thread (screw thread insert) is cut for the wire- thread insert. This thread is often called STI thread (STI=Screw Thread Insert). Then the BaerCoil® thread insert is screwed into the old thread and thus the workpieces are screwed on again. With BaerCoil® thread inserts, the thread produced is significantly more stable than the original thread.
BaerCoil® thread inserts are perfect for applications where a balanced distribution of forces is required. They can withstand both static and dynamic loads and help save support material.
BaerCoil® thread inserts can be shortened with a side cutter or similar, according to the length required.
Dimensions
| Diameter |
1/4 |
|---|---|
| Pitch |
20 |
| Dimension |
UNC 1/4 x 20 |
| Length |
2,0 D |
| T (Length when installed) |
12,7 mm |
| Thread length calculation |
2.0 D means 2 times the diameter: 2 times 6.35 mm=12.7 mm The nominal diameter at UNC 1/4 is approx. 6.35 mm |
Characteristics
| Product group |
Wire thread inserts |
|---|---|
| Product type |
BaerCoil wire thread inserts |
| Thread standard |
UNC: American Unified National Coarse thread according to ANSI B1.1 |
| Direction |
Right |
| Type |
free running |
| Tensile strength at room temperature |
>1400 N/mm² |
| Material |
Stainless Steel V2A (AISI 304, X5CrNi18-10, Material No.: 1.4301) |
| Temperature resistance |
315°C long-term 425°C short-term |
Applications
All normal uses for thread repair and thread reinforcement
Technical drawing
| Diameter |
1/4 |
|---|---|
| Length |
2,0 D |
| T (Length when installed) |
12,7 mm |
| F (Min. - Max. outside diameter of thread insert) |
0,308 '' - 0,330 '' |
| P (depth) |
The thread insert must sit 1/4 - 1/2 turns below the surface |
| B (thread depth with chamfer) |
0,675 '' |
| D (minimum depth of the core hole, without tip) |
0,725 '' |
Video instructions
Further information
Product data sheet
Safety instructions
Zubehör
