BaerCoil Wire Thread Inserts UNF No. 5 x 44 - 2.5 D (7.94 mm) -100 pcs.
BaerCoil Wire Thread Inserts UNF No. 5 x 44 - 2.5 D (7.94 mm) -100 pcs.
BaerCoil® thread inserts provide a long-lasting and powerful thread connection and scrap recovery. The inserts also create load-bearing connections in materials with low shear strength. thread inserts are precise and wear-resistant, holding your screw firmly in place without changing the thread insert. Ideal for repairing stripped or worn threads. wire thread inserts are commonly used in automotive, electrical, medical, lightweight construction, and aerospace applications.
The BaerCoil® thread insert is the perfect solution for damaged threads. With the use of BaerCoil® thread inserts, the thread produced is significantly stronger than the original thread.
BaerCoil® thread inserts are perfect for applications where a balanced distribution of forces is required. They can withstand both static and dynamic loads and help save support material.
BaerCoil® thread inserts can be shortened with a side cutter or similar, according to the length required.
Dimensions
| Diameter |
No. 5 |
|---|---|
| Pitch |
44 |
| Dimension |
UNF No. 5 x 44 |
| Length |
2,5 D |
| T (Length when installed) |
7,94 mm |
| Thread length calculation |
2.5 D means 2.5 times the diameter: 2.5 times 3.18 mm=7.94 mm The nominal diameter for UNF No. 5 is approx. 3.18 mm |
Characteristics
| Product group |
Wire thread inserts |
|---|---|
| Product type |
BaerCoil wire thread inserts |
| Thread standard |
UNF: American Fine Unified National thread according to ANSI B1.1 |
| Direction |
Right |
| Type |
free running |
| Tensile strength at room temperature |
>1400 N/mm² |
| Material |
Stainless Steel V2A (AISI 304, X5CrNi18-10, Material No.: 1.4301) |
| Temperature resistance |
315°C long-term 425°C short-term |
Applications
All normal uses for thread repair and thread reinforcement
Technical drawing
| Diameter |
No. 5 |
|---|---|
| Length |
2,5 D |
| T (Length when installed) |
7,94 mm |
| F (Min. - Max. outside diameter of thread insert) |
0,152 '' - 0,168 '' |
| P (depth) |
The thread insert must sit 1/4 - 1/2 turns below the surface |
| B (thread depth with chamfer) |
0,392 '' |
| D (minimum depth of the core hole, without tip) |
0,414 '' |
Video instructions
Further information
Product data sheet
Zubehör
