BaerCoil Wire Thread Inserts UNC No. 8 x 32 - 1.5 D (6.25 mm) - free running - 10 pcs.
In stock
Express shipping available
BaerCoil Wire Thread Inserts UNC No. 8 x 32 - 1.5 D (6.25 mm) - free running - 10 pcs.
BaerCoil® thread inserts are the best solution for your thread repair! With them you can create long-lasting and powerful threaded connections. The inserts also ensure that you have no waste and recycle everything. The inserts are precise and wear resistant - your screw will stay firmly in place without the thread insert slipping.
The BaerCoil® thread insert is the perfect solution for damaged threads while maintaining the same nominal diameter. For thread repair with wire thread inserts, the thread is drilled out and a new STI thread (screw thread insert) is cut for the wire- thread insert. This thread is often called STI thread (STI=Screw Thread Insert). Then the BaerCoil® thread insert is screwed into the old thread and thus the workpieces are screwed on again. With BaerCoil® thread inserts, the thread produced is significantly more stable than the original thread.
BaerCoil® thread inserts ensure that both static and dynamic work loads are distributed evenly over the individual thread turns. Also, the flexibility of the ® thread inserts compensates for any pitch and angular errors, so that optimum force transmission from the bolt to the nut thread is achieved.
BaerCoil® thread inserts can be shortened according to the required length with a side cutter or similar.
Dimensions
| Diameter |
No. 8 |
|---|---|
| Pitch |
32 |
| Dimension |
UNC No. 8 x 32 |
| Length |
1,5 D |
| T (Length when installed) |
6,25 mm |
| Thread length calculation |
1.5 D means 1.5 times the diameter: 1.5 times 4.17 mm=6.25 mm The nominal diameter at UNC No. 8 is approx. 4.17 mm |
Characteristics
| Product group |
Wire thread inserts |
|---|---|
| Product type |
BaerCoil wire thread inserts |
| Thread standard |
UNC: American Unified National Coarse thread according to ANSI B1.1 |
| Direction |
Right |
| Type |
free running |
| Tensile strength at room temperature |
>1400 N/mm² |
| Material |
Stainless Steel V2A (AISI 304, X5CrNi18-10, Material No.: 1.4301) |
| Temperature resistance |
315°C long-term 425°C short-term |
Applications
All normal uses for thread repair and thread reinforcement
Technical drawing
| Diameter |
No. 8 |
|---|---|
| Length |
1,5 D |
| T (Length when installed) |
6,25 mm |
| F (Min. - Max. outside diameter of thread insert) |
0,201 '' - 0,220 '' |
| P (depth) |
The thread insert must sit 1/4 - 1/2 turns below the surface |
| B (thread depth with chamfer) |
0,355 '' |
| D (minimum depth of the core hole, without tip) |
0,387 '' |
Video instructions
Further information
Product data sheet
Safety instructions
Login