BaerCoil Wire Thread Inserts M 14 x 1.25 - 3.0 D (42 mm) - free running - 50 pcs.
In stock
Express shipping available
BaerCoil Wire Thread Inserts M 14 x 1.25 - 3.0 D (42 mm) - free running - 50 pcs.
BaerCoil® thread inserts are the best solution for all your repair needs! With them you can create long-lasting and powerful connections. These inserts also ensure that you have no waste and recycle everything. The inserts are precise and wear resistant - your screw will stay firmly in place without the thread insert slipping.
The BaerCoil® thread insert is the perfect solution for damaged threads while maintaining the same nominal diameter. For thread repair with wire thread inserts, the thread is drilled out and a new STI thread (screw thread insert) is cut for the wire- thread insert. This thread is often called STI thread (STI=Screw Thread Insert). Then the BaerCoil® thread insert is screwed into the old thread and thus the workpieces are screwed on again. With BaerCoil® thread inserts, the thread produced is significantly more stable than the original thread.
BaerCoil® thread inserts are perfect for applications where a balanced distribution of forces is required. They can withstand both static and dynamic loads and help save support material.
BaerCoil® thread inserts can be shortened with a side cutter or similar, according to the length required.
Dimensions
| Diameter | 14 |
|---|---|
| Pitch | 1,25 |
| Dimension | MF 14 x 1,25 |
| Length | 3,0 D |
| T (Length when installed) | 42 mm |
| Thread length calculation | 3.0 D means 3 times the diameter: 3 times 14 mm=42 mm The nominal diameter for MF 14 is 14 mm |
Characteristics
| Product group | Wire thread inserts |
|---|---|
| Product type | BaerCoil wire thread inserts |
| Thread standard | MF: Metric ISO fine thread according to DIN 13 |
| Tolerance | ISO2/6H |
| Direction | Right |
| Type | free running |
| Tensile strength at room temperature | >1400 N/mm² |
| Material | Stainless Steel V2A (AISI 304, X5CrNi18-10, Material No.: 1.4301) |
| Temperature resistance | 315°C long-term 425°C short-term |
Applications
All normal uses for thread repair and thread reinforcement
Technical drawing
| Diameter | 14 |
|---|---|
| Length | 3,0 D |
| T (Length when installed) | 42 mm |
| F (Min. - Max. outside diameter of thread insert) | 15,47 mm - 17,03 mm |
| P (depth) | The thread insert must sit 1/4 - 1/2 turns below the surface |
| B (thread depth with chamfer) | 46,37 mm |
| D (minimum depth of the core hole, without tip) | 47,62 mm |
Video instructions
Further information
Product data sheet
Safety instructions
Zubehör
