BAER Round Cutting Die UNJF 8 - 36 - HSSE-PM
BAER Round Cutting Die UNJF 8 - 36 - HSSE-PM
BAER thread cutting dies are threading tools that are perfect for external threads. Basically, this cutting tool is cylindrical and - depending on the size - has three or more cutting edges inside. The holes between the cutting edges take up the chips, roll them and carry them away. Dies are commonly used in everyday life to make screws, nuts and threaded rods. The die holder is used to cut the threads by hand and the special die holders also allow you to attach the round die to a tailstock or drill. The dies can usually be used on both sides and have a perfect cut. The die is made of the high-quality high-speed steel HSSE. HSSE is more heat-resistant, more wear-resistant and has a slightly higher hardness. The higher cobalt content makes the tool particularly durable and reliable. The improved surface finish, the spiral entry and the basic material HSSE give you the necessary power for working with difficult-to-cut materials and stainless steels. The cutting tool also has a special cutting edge geometry so that it can be used in metalworking for quenched and tempered steels and case-hardening steels up to 1200 N/mm², as well as stainless and acid-resistant steels, heat-resistant structural steels and malleable cast iron. It is important that you lubricate the tool plumbed working and with cutting oil or cutting paste.
Dimensions
| Height H |
7 mm |
|---|---|
| Diameter |
No. 8 |
| Nominal diameter in inches |
0,164 |
| Nominal diameter in mm |
4,166 |
| Pitch |
36 |
| Pitch in mm |
0,705 |
| Dimension |
UNJF No. 8 x 36 |
Characteristics
| Product group |
Round cutting die |
|---|---|
| Product type |
Round cutting dies |
| Thread standard |
UNJF: American Unified aerospace fine thread according to ISO 3161-1977, BS 4084-1987, MiL-S |
| Tolerance |
3AX |
| Direction |
Right |
| Standard |
DIN 223 (DIN EN 2256 |
| Material |
HSSE |
Technical information - Cutting dies
1,75
HSSE
3AX
Applications
- stainless steels (INOX, V2A, V4A etc.)
- and for general use up to 1200 N/mm²
Technical drawing
| Height H |
7 mm |
|---|---|
| Outside diameter D1 |
20 mm |
| Dimension Diameter D |
UNJF No. 8 x 36 |
| Diameter |
No. 8 |
