BaerCoil Wire Thread Inserts BSW 1.3/8“ x 6 - 1.5 D (52.39 mm) - free running - 10 pcs.
BaerCoil Wire Thread Inserts BSW 1.3/8“ x 6 - 1.5 D (52.39 mm) - free running - 10 pcs.
BaerCoil® wire thread inserts provide a long-lasting and powerful thread connection and scrap recovery in the thread repair. The inserts also create load-bearing connections in materials with low shear strength. thread inserts are precise and wear-resistant and hold your screw firmly in place without changing the thread insert. Ideal for repairing stripped or worn threads. wire thread inserts are commonly used in automotive, electrical, medical, lightweight construction, and aerospace applications.
The BaerCoil® thread insert is the perfect solution for damaged threads. With the use of BaerCoil® thread inserts, the thread produced is significantly stronger than the original thread.
BaerCoil® thread inserts ensure optimum power transmission from the bolt to the nut thread, even in lightweight constructions. Today, they are already an important component in aviation and vehicle construction. They save weight and allow the use of smaller and shorter screw connections.
BaerCoil® thread inserts can be shortened, according to the required length, with a side cutter or similar.
Dimensions
| Diameter |
1.3/8" |
|---|---|
| Pitch |
6 |
| Dimension |
BSW 1.3/8" x 6 |
| Length |
1,5 D |
| T (Length when installed) |
52,39 mm |
| Thread length calculation |
1.5 D means 1.5 times the diameter: 1.5 times 34.93 mm=52.39 mm The nominal diameter at BSW 1.3/8" is approx. 34.93 mm |
Characteristics
| Product group |
Wire thread inserts |
|---|---|
| Product type |
BaerCoil wire thread inserts |
| Thread standard |
BSW: British Whitworth standard thread according to BS 84 |
| Direction |
Right |
| Type |
free running |
| Tensile strength at room temperature |
>1400 N/mm² |
| Material |
Stainless Steel V2A (AISI 304, X5CrNi18-10, Material No.: 1.4301) |
| Temperature resistance |
315°C long-term 425°C short-term |
Applications
All normal uses for thread repair and thread reinforcement
Technical drawing
| Diameter |
1.3/8" |
|---|---|
| Length |
1,5 D |
| T (Length when installed) |
52,39 mm |
| P (depth) |
The thread insert must sit 1/4 - 1/2 turns below the surface |
