BaerCoil Wire Thread Inserts UNC No. 12 x 24 - 1.5 D (8.23 mm) - free running - 10 pcs.
BaerCoil Wire Thread Inserts UNC No. 12 x 24 - 1.5 D (8.23 mm) - free running - 10 pcs.
BaerCoil® thread inserts are the best solution for all your repair needs! With them you can create long-lasting and powerful connections. These inserts also ensure that you have no waste and recycle everything. The inserts are precise and wear-resistant - your screw will stay firmly in place without slipping thread insert.
For thread repair with wire thread inserts, the thread is drilled out and a new STI thread (screw thread insert) is cut for the wire- thread insert. Often this thread is also called STI thread (STI=Screw Thread Insert).
BaerCoil® thread inserts are perfect for applications where a balanced distribution of forces is required. They can withstand both static and dynamic loads and help save support material.
BaerCoil® thread inserts can be shortened with a side cutter or similar, according to the required length.
Dimensions
| Diameter |
No. 12 |
|---|---|
| Pitch |
24 |
| Dimension |
UNC No. 12 x 24 |
| Length |
1,5 D |
| T (Length when installed) |
8,23 mm |
| Thread length calculation |
1.5 D means 1.5 times the diameter: 1.5 times 5.49 mm=8.23 mm The nominal diameter at UNC No. 12 is approx. 5.49 mm |
Characteristics
| Product group |
Wire thread inserts |
|---|---|
| Product type |
BaerCoil wire thread inserts |
| Thread standard |
UNC: American Unified National Coarse thread according to ANSI B1.1 |
| Direction |
Right |
| Type |
free running |
| Tensile strength at room temperature |
>1400 N/mm² |
| Material |
Stainless Steel V2A (AISI 304, X5CrNi18-10, Material No.: 1.4301) |
| Temperature resistance |
315°C long-term 425°C short-term |
Applications
All normal uses for thread repair and thread reinforcement
Technical drawing
| Diameter |
No. 12 |
|---|---|
| Length |
1,5 D |
| T (Length when installed) |
8,23 mm |
| F (Min. - Max. outside diameter of thread insert) |
0,265 '' - 0,283 '' |
| P (depth) |
The thread insert must sit 1/4 - 1/2 turns below the surface |
| B (thread depth with chamfer) |
0,470 '' |
| D (minimum depth of the core hole, without tip) |
0,512 '' |
