BaerCoil Wire Thread Inserts UNF No. 4 x 48 - 2.0 D (5.69 mm) -10 pcs.
BaerCoil Wire Thread Inserts UNF No. 4 x 48 - 2.0 D (5.69 mm) -10 pcs.
BaerCoil® wire thread inserts not only ensure a long-lasting and powerful threaded connection in the thread repair, but also enable scrap recovery. The inserts also create load-bearing connections in materials with low shear strength. Thanks to their precision and wear resistance, the BaerCoil® thread inserts hold your screw firmly in place without changing the thread insert. Ideal for repairing stripped or worn threads. wire thread inserts are often used in automotive, electrical, medical, lightweight construction, and aerospace applications.
The BaerCoil® thread insert is the perfect solution for damaged threads. STI thread (screw thread insert) is cut and the BaerCoil® insert is screwed in. The thread produced is significantly stronger than the original thread.
BaerCoil® thread inserts ensure optimum power transmission from the bolt to the nut thread. The flexibility of the thread inserts compensates for any pitch and angular errors so that the loads are distributed evenly over the individual threads. BaerCoil® thread inserts are ideal for lightweight constructions, as they reduce the carrier material and enable smaller or shorter screw connections. Today, they are already an important component in aviation and vehicle construction.
BaerCoil® thread inserts can be shortened according to the required length with a side cutter or similar.
Dimensions
| Diameter |
No. 4 |
|---|---|
| Pitch |
48 |
| Dimension |
UNF No. 4 x 48 |
| Length |
2,0 D |
| T (Length when installed) |
5,69 mm |
| Thread length calculation |
2.0 D means 2 times the diameter: 2 times 2.84 mm=5.69 mm The nominal diameter for UNF No. 4 is approx. 2.84 mm |
Characteristics
| Product group |
Wire thread inserts |
|---|---|
| Product type |
BaerCoil wire thread inserts |
| Thread standard |
UNF: American Fine Unified National thread according to ANSI B1.1 |
| Direction |
Right |
| Type |
free running |
| Tensile strength at room temperature |
>1400 N/mm² |
| Material |
Stainless Steel V2A (AISI 304, X5CrNi18-10, Material No.: 1.4301) |
| Temperature resistance |
315°C long-term 425°C short-term |
Applications
All normal uses for thread repair and thread reinforcement
Technical drawing
| Diameter |
No. 4 |
|---|---|
| Length |
2,0 D |
| T (Length when installed) |
5,69 mm |
| F (Min. - Max. outside diameter of thread insert) |
0,137 '' - 0,162 '' |
| P (depth) |
The thread insert must sit 1/4 - 1/2 turns below the surface |
| B (thread depth with chamfer) |
0,297 '' |
| D (minimum depth of the core hole, without tip) |
0,318 '' |
Video instructions
Further information
Product data sheet
Safety instructions
Zubehör
